
A feeder is a type of bottom fishing tackle. It's a convenient and effective tool for catching trophy specimens. However, to land a predator in the fast current of a mountain river, you need to know the proper fishing techniques.
How to fish with a feeder rod on a mountain river
In fast currents, feeder fishing has its advantages, but requires special knowledge:
1. The main rule is to accurately determine the required distance and casting point. For this type of fishing on the Putorana River, you can use rods and spinning rods. or casting rods. The main thing is that they are equipped with thick, dense fishing lines.
2. The location is determined by the bottom's condition. It's important to determine whether it's level or whether there are holes, rocks, depressions, etc. This can be determined using echo sounders or by making several test casts. The location is determined by casting as follows: if there are vibrations during the cast, the bottom is littered with rocks.



Selecting feeder fishing gear
Equipment is selected based on the conditions. Trophy fishing allows you to target large predators. The bait attracts numerous non-predatory fish, which then attract the attention of bloodthirsty whitefish and grayling. This then allows you to catch them in large numbers.
- To achieve this, in the mountain reservoirs of the Krasnoyarsk Territory, the fishing line must be stiffer, not stretchable, with a thickness of approximately 0.2 mm.
- For successful fishing of grayling, whitefish, and other predatory fish that avoid the hook—considered shy and concerned about their safety—clear fluorocarbon leaders are used. Their advantages include invisibility, fast sinking, and resistance to any temperature fluctuations. A disadvantage can be their diameter, which is considered large.
- The feeders are equipped with dark-colored swivels. These tones don't disturb the fish with bright colors.
- Hooks must be suitable for large trophy predators. Therefore, they should not bend or break.
- A feeder is selected to suit the bait, with a capacity of approximately 2 kilograms. Open models are used to scatter bait where needed, while closed models are suitable for loose bait. The feeder should be secured with large-diameter fishing line to withstand the strong current of a mountain river. The mesh size should be chosen accordingly: the slower the current, the larger the mesh size, and vice versa.
- The load should be approximately 2 kg or more.
How to fish with a feeder
The key to feeder fishing is casting to a specific spot with a slow, tugging motion. Mixed plant foods are used for bait. Breadcrumbs, corn, oatmeal, and spices like cinnamon, which have strong aromas, can also be used.
Fast current feeder mounts
Asymmetrical loop
The most common attachment for a fishing tackle is an asymmetrical loop. For a feeder on a mountain river, a flat feeder is commonly used, but reliable hooks and thick line are essential. To allow the bait to be placed deeper, closer to the bottom, monofilament line is used. Braided lines are not used, as they tend to tangle.
Symmetrical loop
It can be done as follows:
- About 30 cm of the tackle is tied with a figure-eight knot;
- Using the same knot, make a 10 cm twist;
- The swivel is put on and then moved to the knot;
- From the first knot, measure 15 cm and make a second one;
- All unnecessary things are removed, and the feeder is attached to the swivel.
The "Helicopter" feeder rig
To catch predators in fast currents, use this rig:
- A fluorocarbon line slightly over a meter long is folded in half;
- Step back 15 cm and put a swivel on the figure eight knot;
- Again, leave a 1 cm gap and tie a knot. A clasp with a swivel is inserted into the loop under the feeder;
- After which the leash is tied to the swivel between the knots.
With this setup, the feeder can move freely, while the leash will rotate around the base.
This is what feeder mounts for mountain river currents look like.



