
DIY PVC Boat Valve Repair. Fishing trips on the Putorana Plateau are conducted using PVC boats, so it's important to understand how to perform repairs yourself. This article explains how to repair PVC boat valves yourself.
As we described in previous articles, to repair the damage, you'll need to assemble a set of necessary tools and materials. Afterward, you can carry out the boat repairs yourself.
What will be needed for repairs?
If the valves are leaking air, it's time to replace them. To do this, you'll need the following tools:
· Acetone;
· Soap;
· Polyvinyl chloride gaskets;
· New set of valves;
· Two-component polyurethane adhesive;
· Special key;
· Construction hair dryer;
· Tassels.
Before removing the valves, they must be unscrewed, but don't do this with a regular screwdriver. This can damage the valve stem threads. Therefore, it's best to use a wrench.



Step-by-step instructions for changing valves on a PVC boat
1. First, it is necessary to release air from the cylinders.
2. Then, feel the glass, the base of the valve, and fix it with your palm.
3. Insert the key and unscrew it. Turn it counterclockwise.
4. To remove the cup and flange, make small cuts in the support ring, approximately 1 centimeter each. Heat it with a hair dryer and remove it.
5. After removing the old glass, carefully insert the new one and move it slightly to one side.
6. Next, prepare the glue according to the instructions provided, and then apply it to the area that needs to be glued.
7. After approximately 15 minutes, heat all parts to be glued with a hair dryer to 80°C and press them into place. Roll the patches as you do this.
8. Finally, place the glass back in its work place and screw it on.
After completing the work, the boat should be left for 24 hours, and after 24 hours, a test run can be performed. If everything is in order, the boat is ready for fishing again. However, it's also worth noting that valves sometimes leak air due to accumulated dirt and dust. To check for this, you'll need to flush the mechanisms and then apply grease to the valve spring.
Conclusion
We've explained how anglers can replace valves on PVC boats themselves. It's worth noting that all repairs are quite easy to do yourself, avoiding the cost of hiring a professional for a large replacement.
A watercraft must meet all safety requirements, so delaying repairs is absolutely essential. In the future, we'll publish other repairs that will restore a PVC boat to service and provide significant benefits to anglers. Without a boat, you're lost on the water, so it's important for this asset to function reliably and for a long time.



